Instructions About Electrics And Electronics; Lighting System - Stromer ST2 Operating Manual

INSTRUCTIONS ABOUT ELEC-
TRICS AND ELECTRONICS
You can find information about the bike's op-
eration, maintenance, upkeep and technical data
in this Instruction Manual, under
www.stromerbike.com/support and on each of
the component manufacturer's websites.
The electrical installation of your S-pedelec
is very powerful. Correct and safe operation re-
quires you to have your Stromer regularly main-
tained by a Stromer dealer. Have your S-pedelec
regularly maintained by a Stromer dealer. They
will check the current software status and ensure
that important updates that affect the safety and
riding comfort are installed.
Immediately switch off the electrical system and
remove the battery when you notice damage to
the electrical system or, for example, when live
parts are exposed after a fall or accident.
Always contact your Stromer dealer when you re-
quire repairs, want to ask a question, experience
problems or discover a defect. A lack of technical
knowledge can lead to severe accidents or dam-
age!
Always turn off the electrical system and
remove the battery before doing any kind of work
on your S-pedelec. Ensure that the charger is not
connected.
If your Stromer S-pedelec does not start, al-
though no error message is shown, check whether
both brake levers are in their initial position! No
motor power is transmitted when one of the brake
levers is activated!

LIGHTING SYSTEM

When the daytime running light is activated, it is
on whenever the Stromer is switched on. (See day-
time running light www.stromerbike.com/com/
support). The daytime running light is dimmed
when the headlight is switched on, so that drivers
in oncoming vehicles are not blinded.
The daytime running light is not legal in certain
countries and can accordingly not be activated
there. Please stay informed regarding the legal
situation!
We recommend activating the daytime run-
ning light at all times, as far as this is permitted
in the respective country. You can then more
easily be seen by other traffic participants and
thus increase road traffic safety.
A working lighting system is essential for
your safety! Have the installation, inspection and
repair performed by a Stromer dealer.
S-pedelecs used on public roads have to be
equipped with a generator, a battery providing a
nominal voltage of 6 V (permanent battery light-
ing) or a rechargeable energy storage device as
an energy source for powering the head light and
the tail light. The lighting system of the Stromer
is powered by the battery or, when this has been
drained, by a motor with dynamo function.
Stromer S-pedelecs are provided with lights based
on the latest LED technology.
It is not possible to replace the bulbs in
modern LED lights. Clean your reflectors and
lights on a regular basis. Warm water with clean-
ing fluid or washing up liquid is suitable here.
It is recommended to adjust the headlight point-
ing downwards so that the center of the light cone
emitted drops to half its height between the head-
light and a point at a distance of 5 m. The law in
Germany prescribes this setting.
Changes to the lighting system are not permitted
and may lead to a loss of warranty, guarantee and
insurance cover!
Additional information regarding this issue is pro-
vided at www.stromerbike.com/support