Stromer ST2 Operating Manual page 7

The writing "THIS SIDE UP" must be visible
on the top.
b) Charge battery internally
Only charge the Stromer battery with a
Stromer charger.
2) Switch on the electrical system
The power button is located at the bottom of the
top tube, below the touch screen.
The motor of the Stromer only starts up
once a minimum speed has been reached to en-
sure your safety. Always keep one brake engaged
before placing the first foot onto the pedal. The
strong acceleration feels very unfamiliar. Uncon-
trolled starting up in road traffic or on loose
ground can lead to a fall or severe injuries. Prac-
tice operating and riding your Stromer in a quiet
and safe place before you take to public roads!
Never ride when the battery is not inserted.
The battery compartment can in this case not be
locked. This poses an additional risk of falls and
injuries.
The Stromer can obviously also be used like
a normal bicycle without a motor.
The motor support depends on the force that acts
on the pedals. The more firmly you step onto the
pedals, the stronger the support from the motor.
The motor support stops when you stop pushing
the pedals during the ride. Motor support is only
reactivated when you start working the pedals.
The boost mode is activated when the plus
button on the operating element is pressed and
held for two seconds! The Stromer will then ac-
celerate without pedal support to a speed of
20 km/h! This boost mode only kicks in at a driv-
ing speed above 0.5 km/h.
Operating element
Important functions of the Stromer can be con-
trolled while riding and without taking your hands
off the handlebar, by using the operating element
on the handlebar.
Switch on the
light/main light
Support mode
Plus
Support mode
Minus
Basic settings Driving mode Touchscreen display