Material Supply Tracks - Scotchman CPO 350 Manual

7.3 MATERIAL SUPPLY TRACKS

A ten foot roller supply track, that can be bolted to the input side of the saw to support longer pieces of
material, is an available option for this saw. The supply tracks can also be bolted end to end, to supply
longer tracks, if needed. The ten foot supply track bolts to the machine on the left side of the base casting.
SEE FIGURE 21 ON THE FOLLOWING PAGE.
1. Attach the roller support bracket (N) to the left side of the base casting with the 10 x 30mm hex head
bolts and lock washers provided.
2. Bolt the legs (B) to the rail assembly (A) with the remaining 10 x 30mm hex head bolts.
3. Place the two remaining 10 x 80mm hex bolts through the end of the rail assembly and lock them in
place with the hex nuts.
4. Thread another nut on each bolt and attach the track to the support bracket with the remaining two
10mm hex nuts.
5. Space the rollers along the rail at an even spacing.
6. Adjust the supply track so that the rollers are at the same level as the bed of the material vise on the
saw. The track is adjusted by loosening the bolts in the legs and the bolts that attach the support
bracket to the track.
7. The track may be anchored to the floor, using the mounting holes provided.
8. The optional vertical guide assembly (F) can be used as a guide for materials that do not lay flat on the
feed roller.
PAGE 48