Hitachi G200 User Manual page 83

the specified maximum number, and starts additional pairs after one
of the specified number is synchronized.
For example, if you specify 70 for Maximum Initial Copy Activities
and then create 75 pairs, the system starts the first 70 pairs but does
not start the 71st pair until one of the pairs is synchronized.
b For Blocked Path Monitoring, enter the number of seconds for the
.
system to monitor blocked paths. The range is from 2 to 45 seconds;
40 is the default.
If all paths become monitored because of path error, an MIH may
occur in the host. Therefore, the time you specify must be less than
the host's MIH timer setting.
c For Blocked Path SIM Monitoring, enter the number of seconds for
.
the system to monitor SIMs reported for blocked paths. The range is
from 2 to 100 seconds.
d For Services SIM of Remote Copy, specify whether or not services
.
SIMs in the remote CU are reported to the host.
5 Change CU Options as needed. Settings apply to the CU only.
.
a Select the CU with the options to be changed, and then click Change
.
CU Options. If you do not want to change CU options, click Finish.
b In the Change CU Options dialog box, for Maximum Initial Copy
.
Activities, specify the number of volumes to be copied concurrently
per initial copy operation for the CU. The range is from 1 to 16
volumes.
This option is available only when Maximum Initial Copy Activities
is Enable.
c For Services SIM of Remote Copy, specify whether or not services
.
SIMs in the remote CU are reported to the host.
d Click OK.
.
6 In the Edit Remote Replica Options window, click Finish.
.
7 In the Confirm window, review the settings and enter a task name in the
.
Task Name box.
8 Click Apply to save your settings in the system.
.
Hitachi TrueCopy® User Guide for Hitachi Virtual Storage Platform Gx00 and Fx00 Models
TC configuration
5-7