Main Function - ACME PAGEANT CM-600z User Manual

DMX
3. Button:
MENU
DOWN
UP
ENTER
4. DMX IN:
DMX512 link, use 3/5-pin XLR cable to link the unit and the DMX controller
5. DMX OUT:
DMX512 link, use 3/5-pin XLR cable to link the next unit and output DMX signal
6. MAINS IN:
PowerCon connection from main power supply
7. MAIS OUT:
PowerCon loop connection for main power supply to the next unit
8. Fuse (T 10A):
Protects the unit from over-voltage or short circuit

3.2 Main Function

To select any of the given functions, press the MENU button until the required function is showing
on the display. Select the function by pressing the ENTER button and the display will blink. Use the
DOWN/UP buttons to change the mode. Once the required mode has been selected, press the
ENTER button to setup, to go back to the functions without any change press the MENU button
again. Press and hold the MENU button for about one second or wait for one minute to exit the
menu mode.
The main functions are shown overleaf:
ON DMX input present
To select the programming functions
To go backward in the selected functions
To go forward in the selected functions
To confirm the selected functions
5A