Mitsubishi HMA100V Technical Manual page 91

9.0 [S] Service menus
9.4 [S] Quick start
9.5.0 [S] System info
9.6.0 [S] Heat reg. settings
9.7 [S] Reset alarm
9.8.0 [S] Alarm log
9.3.10.0 [S] Floor drying setting
9.3.11 [S] Supply pump exer.
9.3.12 [S] Supply diff HP
9.3.13 [S] Diff HP add. heat
9.3.14 [S] Block HW/Heating
9.3.15 [S] Heat drop at alarm
9.3.16 [S] Type of HW sensor
9.3.17 [S] Freeze protection HX
9.3.18 [S] Return
9.5.1 [S] Heat pump type
9.5.2 [S] Cpu usage percent
9.5.3 [S] Com rate/1000
9.5.4 [S] Unit w. com. problem
9.5.5 [S] Run time add. heat
9.5.6 [S] Run time hot water
9.5.7 [S] Program version
9.5.8 [S] 106-card version
9.5.9 [S] Display version
9.5.10 [S] Relay card version
9.5.11 [S] Lowest supply temp.
9.5.12 [S] Percent runtime
9.5.13 [S] Period
9.5.14 [S] Run status
9.5.15 [S] Run status last
9.5.16 [S] Run status time
9.5.17 [S] Return
9.6.1 [S] CompFreq
9.6.2 [S] Manual CompFreq
9.6.3 [S] Max deltaF
9.6.4 [S] CompFreq regP
9.6.5 [S] Time min freq start
9.6.6 [S] Time min freq heat
9.6.7 [S] Max diff flow-cFlow
9.6.8 [S] CompFreq GMz
9.6.9 [S] Return
9.8.1.0 [S] Log 1
- 90 -
9.3.10.1 [S] Floor drying
9.3.10.2 [S] Period time 1
9.3.10.3 [S] Temp. period 1
9.3.10.4 [S] Period time 2
9.3.10.5 [S] Temp. period 2
9.3.10.6 [S] Return
9.8.x.1 [S] Time
9.8.x.2 [S] Alarm type
9.8.x.3 [S] Run status
9.8.x.4 [S] Run status last
9.8.x.5 [S] Run status time
'10 • HM-T-149
Control
Control