Servicing The Battery Pack - Dolphin 7400 User Manual

Status LED
Green
Orange
Red
Status of LEDs during Charging Cycle
To remove a battery pack, push the locking tab down and pull the battery out from
the charging pocket with a hinging motion.

Servicing The Battery Pack

To service battery packs, insert batteries into the charging pockets and press the
Condition button. The Condition LED will flash during the conditioning cycle. This
starts an automatic process in which batteries are completely discharged and
then recharged to full capacity in eight hours. The Condition and Calibrate cycle
resets and calibrates battery data so that the user gets longer, more consistent
performance from the batteries. HHP recommends that battery packs should be
serviced, or calibrated, once a month.
Because the Dolphin QuadCharger is accumulating battery pack information
during the entire Condition and Calibrate cycle, it is important not to remove the
battery until the cycle has been completed and the Condition LED is no longer
flashing. Batteries inserted after the "Condition and Calibrate" switch has been
depressed will receive a standard charge. The chart below describes the Status
LEDs during the Condition and Calibrate cycle:
Status LED
Solid Green
Flashing Orange
Solid Red
Status of LEDs during Condition and Calibrate Cycle
•
•
•
80
•
•
•
Description
Charging is complete and
battery is ready for service.
Battery is being charged at a
maximum charge rate
Error was encountered during
charge cycle
Description
Cycle is complete. Battery
remains in trickle charge until
removed from the charger.
Battery is being conditioned
Error was encountered during
charge cycle