Dolphin 7400 User Manual page 10

Table of Contents

Advertisement

Dolphin 7400/7450 RF Terminal with Cisco® 352 Radio
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions. The user may find the following booklet
helpful: "Something About Interference." This is available at FCC local regional
offices. Our company is not responsible for any radio or television interference
caused by unauthorized modifications of this equipment or the substitution or
attachment of connecting cables and equipment other than those specified by our
company. The correction will be the responsibility of the user. Use only shielded
data cables with this system.
CAUTION: To comply with FCC RF exposure compliance requirements, a separation
distance of at least 2 inches (5 cm) must be maintained between the antenna of this
device and all persons (excluding hands, wrists, feet and ankles), during normal
operation.
This device and its antenna must not be co-located or operating in conjunction with
any other antenna or transmitter.
This device is not specified or designed for body-worn configurations. Use of any
body-worn accessories may not ensure compliance with the FCC RF exposure
guidelines.
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

7450

Table of Contents