Charging Batteries In The Quadcharger; Setting Up The Quadcharger; Supplying Power To The Quadcharger; Inserting And Removing Battery Packs - Dolphin 7400 User Manual

Table of Contents

Charging Batteries In The QuadCharger

Follow these steps to charge batteries in the QuadCharger:

1. Set up the charger for use

2. Supply power

3. Insert batteries

CAUTION: Do not attempt to recharge any battery pack in the Dolphin 7400

QuadCharger that is not manufactured by HHP especially for this device. To do so

will void your warranty and could damage the Dolphin 7400 QuadCharger.

The Dolphin QuadCharger should be set up on any dry, stable surface. DIN rail

slots on the bottom panel allow the charger to be wall or desktop-mounted for

easily adapting the unit to your environment.

The charger must be connected to a power source for any type of operation.

CAUTION: Using a non-HHP power cord voids your warranty and could result in

serious damage to the Dolphin QuadCharger's circuitry.

Locate the AC power cord that came with the Dolphin QuadCharger. Plug the

cord into the power supply connector on the back of the unit and then plug the

power cord into a wall socket.

Press and hold the Power Switch for approximately one second, then release, to

turn on the Dolphin 7400 QuadCharger. The GREEN power LED will illuminate

and the charger will undergo a self-diagnostic test.

To insert a battery pack, place the end of the battery without the locking tab into

the bottom of the charging pocket and snap the battery into place with a hinging

motion. Once the battery is properly seated, the orange status LED for that

particular pocket will illuminate.

For best results, battery packs should be at room temperature before recharging

them; temperature has a marked effect on charging. The recommended

temperature range is 50° to 95° F (10° to 35° C).

The LEDs indicate the charging status of batteries as described in the chart

shown on the next page:

•

Table of Contents

7450