Setting Up For Communications With The Usb Homebase - Dolphin 7400 User Manual

To configure the Dolphin 7400/7450 terminal for communications, see the
previous section on

Setting Up For Communications With The USB HomeBase

To use the USB HomeBase, you need the following equipment:
•
USB HomeBase with power supply
•
USB Cable
•
CD with USB-IrDA drivers
•
Windows® 98, Windows® Me or Windows® 2000 computer.
Note: The USB HomeBase does not support Windows NT®
To install the USB HomeBase, follow these steps:
1. Plug in the power supply and connect it to the back of the USB HomeBase.
2. Plug the USB cable into the back of the USB home base.
3. Plug the other end of the USB cable into your PC.
At this point, a dialog box appears on your PC instructing you that the system has
detected new hardware and it is searching for the HHP USB-IrDA driver. Unless
you have previously installed the USB HomeBase, the OS will be unable to find
one and the Found New Hardware Wizard screen shown below will display on
your PC's screen.
•
•
•
70
•
•
•
ActiveSync Connection Settings
Configuring the Dolphin Terminal
.