Communicating With The Dolphin Terminal - Dolphin 7400 User Manual

To configure the Dolphin 7400/7450 terminal for communications, see the
previous section on

Communicating with the Dolphin Terminal

To communicate with the Dolphin and any other devices connected to the Dolphin
Charging/Communication cradle:
1. Insert the Dolphin into the terminal well of the HomeBase/IntelliBase/USB HomeBase.
If the Dolphin is in sleep mode, it will awaken into active state.
2. The DOCK LED on the cradle will illuminate. If the Dolphin does not turn on, or the LED
does not light up, make sure that it is properly seated in the terminal well and that the
power supply is properly connected to the cradle and plugged into a functioning AC out-
let.
3. Start your application on the Dolphin terminal or the host computer. Data can then
begin transmitting between the terminal and the devices connected to the Dolphin cra-
dle.
When data transfer begins, the COMM LED on the cradle will blink red and green.
If the HomeBase/IntelliBase/HomeBase will not communicate with the Dolphin,
check the port connections to ensure that the cradle is correctly configured.
•
•
•
72
•
•
•
ActiveSync Connection Settings
Configuring the Dolphin Terminal
.