Dolphin 7400 User Manual page 17

power and the back-up battery is required. The back-up battery maintains the
RAM and clock when the NiMH main battery pack is discharged or removed from
the terminal.
Removing the Battery Pack
Follow these steps to remove the Dolphin battery pack.
1. Hold the Dolphin with the front panel (keyboard) facing down.
2. On the 7400, remove the handstrap by pushing its clip down and forward to
unhook it from the terminal; move the strap away from the battery compart-
ment.
3. Push the locking tab on the battery pack up and pull the battery out from the
Dolphin terminal with a hinging motion.
Inserting the Battery Pack
Follow these steps to install the Dolphin 7400 battery pack.
1. The Dolphin 7400 ships with the handstrap installed. Hold the terminal with the
front panel (keyboard) facing down. Push the clip of the handstrap down and
away from the terminal to unhook it; move the strap up and away from the bat-
tery compartment.
2. Insert the end without the locking tab into the top of the battery opening and
snap the battery into place with a hinging motion. Press the battery into the well
until the clip is engaged. The battery case serves as the back cover of the Dol-
phin.
3. Reattach the handstrap by positioning it down over the battery case and sliding
the clip back into the place at the bottom end of the 7400.
4. The terminal will initialize and, after a few seconds, will show the splash screen
for the Dolphin 7400 demo program.
Follow these steps to install the Dolphin 7450 battery pack.
1. Hold the terminal with the front panel (keyboard) facing down.
2. Insert the end without the locking tab into the top of the battery opening and
snap the battery into place with a hinging motion. The battery case serves as
the back cover of the Dolphin.
3. The terminal will initialize and, after a few seconds, will show the splash screen
for the Dolphin 7400 demo program.
3 Turning the Dolphin On And Off
Turning the Dolphin On For the First Time
Turning on the Dolphin 7400/7450 for the first time is a
steps to turn on your Dolphin 7400/7450 terminal.
1. Install the charged battery pack in the Dolphin.
2. The red LED will come on and the green LED will blink for approximately three
seconds.
NOTE: DO NOT PRESS ANY KEYS WHILE THE TERMINAL IS BOOTING
UP.
. Follow these
cold boot
17
•
•
•
•
•
•