Attaching The Hotshoe; Closing The Housing - Ikelite 6961.85 User Manual

Attaching the Hotshoe

1. Make sure the contact points are clean on the Hotshoe Camera
Mount and Hotshoe.
2. Slide the Hotshoe onto the Hotshoe Camera Mount.
Hotshoe Camera
Mount
3. Push the Hotshoe forward until it is unable to go any farther. The
Hotshoe must be pushed all of the way forward to make proper
contact with the camera and provide TTL operation.

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The main o-ring does not require lubricant to make
a seal.
2. Place the back onto the housing front.
3. Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
4. Place each lid snap into the corresponding hook on the housing
back.
Hotshoe
9