Setting Up An External Strobe; About The Built-In Flash; About Sync Cords; Attaching A Sync Cord - Ikelite 6961.85 User Manual

Setting Up An External Strobe

About the Built-In Flash

Due to the opaque housing design, the camera's built-in flash
CANNOT be used alone to light a subject underwater. The camera's
built-in flash CAN be used to trigger fiber optic strobes. An external
strobe may be triggered by either electrical Sync Cord or Fiber Optic
Connector.
We recommend attaching an external strobe for the optimal color
and clarity in a wide variety of shooting situations, including daylight
photography.

About Sync Cords

Attaching a strobe via electrical sync cord provides faster strobe
recycle times as compared to a fiber optic connection, and prolongs
camera battery life.
When a compatible Ikelite DS strobe is attached via sync cord,
circuitry built into the housing allows the strobe to communicate
directly with the camera to trigger the strobe and adjust its power for
perfect exposure.
Strobes from SEA&SEA, INON, and Nikonos attached by electrical
sync cord are not capable of powering the TTL circuitry built into this
housing. These strobes must be used in manual power modes when
connected via electrical sync cord.

Attaching a Sync Cord

A bulkhead cap or sync cord must be attached to the housing for
waterproof operation. Never submerge the housing without either
a sync cord or waterproof bulkhead cap attached.
1. Remove the bulkhead cap.
13