Inserting The Camera - Ikelite 6961.85 User Manual

Inserting the Camera

1. Remove any lanyard or neck strap which may be attached to the
camera.
2. Check to see whether the camera lens will fit through the port
opening of the housing. If not, the lens will need to be removed
from the camera body and reattached AFTER the camera body is
installed in the housing.
3. Remove the camera Mounting Tray from the housing.
4. Line up the Mounting Screw with the camera's tripod socket. Use a
coin or flat head screwdriver (preferred) to tighten the Mounting
Tray to the camera. Tray should be tight against camera bottom.
Mounting Tray
Bottom
Tray
View
5. Pull out on the housing control knobs to move them out of the way.
6. DO NOT install camera with flash open. Doing so will result in
insufficient light output through the fiber optic windows.
7. Insert the Mounting Tray into the slot on the inside bottom of the
housing. Push the camera all of the way forward until the back of
the Mounting Tray is flush with the back of the housing tray mount.
8
1/4-20 Mounting Hole
Mounting Screw
Camera Tripod Socket
Camera Bottom
Side Tray View