•
Make sure the hotshoe is pushed all the way forward in the camera
mount.
•
Make sure that the camera flash is set to fire on every photo.
•
Check that the fiber optic cord(s) or sync cord is properly attached.
Buttons are stuck
•
Soak the housing in lukewarm fresh water. Depress each button
several times while the housing is submerged.
•
Push button in all the way and apply lubricant to the button shaft.
Press the button several times to distribute the lubricant.
Button(s) or control(s) do not line up
•
Ensure that nothing is preventing the camera from going into the
housing.
•
Push the camera Mounting Tray forward until it is flush with the
housing tray mount.
Camera is not functioning normally underwater
•
Ensure that the camera Mounting Tray is pushed all of the way into
the housing tray mount.
•
Check each housing control while underwater to ensure that
they are disengaged. An inadvertently engaged control may limit
functioning of the camera.
•
Check that the zoom control is returned to the center position.
Backscatter or "snow" in images
•
Position strobes or lights farther away from your lens and at a slight
angle. Try not to "light up" water between the camera lens and
subject.
•
Avoid using strobes in extremely low-visibility conditions.
18