Warning; Safety Instructions - PR 9116 User Manual

The following operations should only be carried out on a discon-
nected device and under ESD-safe conditions:
Repair of the device and replacement of circuit breakers must
be done by PR electronics a/s only.
Do not open the front plate of the device as this will cause dama-
ge to the connector for the display / programming front PR 4501.
This device contains no DIP-switches or jumpers.
Triangle with an exclamation mark: Read the manual before installation
and commissioning of the device in order to avoid incidents that could lead
to personal injury or mechanical damage.
The CE mark proves the compliance of the device with the essential
requirements of the directives.
The double insulation symbol shows that the device is protected by
double or reinforced insulation.
Ex devices have been approved according to the ATEX directive for use in
connection with installations in explosive areas. See installation drawings
in appendix.
DEFiniTiOns
Hazardous voltages have been defined as the ranges: 75...1500 Volt DC, and
50...1000 Volt AC.
Technicians are qualified persons educated or trained to mount, operate, and also
troubleshoot technically correct and in accordance with safety regulations.
Operators, being familiar with the contents of this manual, adjust and operate
the knobs or potentiometers during normal operation.
2
General mounting, connection and disconnection of wires.
Troubleshooting the device.
symbOl iDEnTiFiCaTiOn

saFETy insTRUCTiOns

9116 - Product Version 9116-003

WaRning

WaRning