Warning - PR 5225 User Manual

This module is designed for connection to hazardous electric
volt ages.
Ignoring this warning can result in severe personal injury or
mechanical damage.
To avoid the risk of electric shock and fire, the safety instructions
GENERAL
of this manual must be observed and the guidelines followed.
The specifications must not be exceeded, and the module must
only be applied as described in the following.
Prior to the commissioning of the module, this manual must be
examined carefully.
Only qualified personnel (technicians) should install this module.
If the equipment is used in a manner not specified by the manufac-
turer, the protection provided by the equipment may be impaired.
Until the module is fixed, do not connect hazardous voltages to
the module.
The following operations should only be carried out on a
disconnected module and under ESD safe conditions:
HAzARD-
Dismantlement of the module for setting of dipswitches
OuS
and jumpers.
VOLT AGE
General mounting, connection and disconnection of wires.
Troubleshooting the module.
Repair of the module and replacement of circuit breakers
must be done by PR electronics A/S only.
SYSTEM 5000 must be mounted on DIN rail according to DIN
46277. The communication connector of SYSTEM 5000 is
connected to the input terminals on which dangerous voltages
INSTAL-
can occur, and it must only be connected to the programming
LATION
unit Loop Link by way of the enclosed cable.
18

WARNING

WARNING
WARNING
SyMBOL IDENTIfIcATION
Triangle with an exclamation mark: Warning / demand. Potentially
lethal situations.
The cE mark proves the compliance of the module with the essential
requirements of the directives.
The double insulation symbol shows that the module is protected by
double or reinforced insulation.
19