IBM 8364 E series User Manual page 92

Error code
NSB51500
NSB51510
NSB61500
NSB61510
NSB61520
NSB61530
NSB61569
NSB61610
NSB61620
NSB61639
NSB61639
80
IBM Network Station
Error message
CompactFlash card messages (NSB51xxx)
File not found on flash
card.
Cannot close file on
flash card.
Token Ring messages (NSB61xxx)
Token Ring PCI device
not detected.
Token Ring PCI device
soft reset failed.
Token Ring PCI device
initialization timed out.
Token Ring PCI device
initialization not
complete.
Token Ring open
command canceled due
to failure.
Token Ring flash
contents not valid.
Token Ring flash
contents not valid.
Token Ring error in
loop back test phase.
Token Ring error in ring
insertion phase.
What you should do
Check the contents of the CompactFlash
card.
Check the contents of the CompactFlash
card.
Restart the Network Station. If the
symptom remains, replace the Network
Station logic unit, or the PCI Token-ring
card.
Restart the Network Station. If the
symptom remains, replace the Network
Station logic unit, or the PCI Token-ring
card.
Restart the Network Station. If the
symptom remains, take any actions
recommended by the text messages that
accompany this message. If you still
cannot resolve the problem, replace the
Network Station logic unit, or the PCI
Token-ring card.
Adapter failed to insert into ring.
Perform any actions recommended by
the messages that accompany this error.
EEPROM microcode corruption. Replace
the Network Station logic unit (see
"Chapter 2. Replacing Network Station
parts" on page 9).
Indicates stage of Token-ring adapter
insertion. Watch for any messages that
accompany this message.
Indicates stage of Token-ring adapter
insertion. Watch for any messages that
accompany this message.
Indicates stage of Token-ring adapter
insertion. Watch for any messages that
accompany this message.