IBM 8364 E series User Manual page 83

Network Station to begin the startup sequence. Refer to the
"Chapter 10. Startup sequence of Network Stations configured
for the IBM Network Station Manager program" on page 67 for a
detailed explanation of the Network Station startup sequence.
Yes No
See "Indicators of Network Station problems" on page 73.
__ 4. Is there a steady green indication from the system LED during the
Network Station startup sequence? See "Hardware layout" on page 4
for the location of the system LED.
Yes No
See "Indicators of Network Station problems" on page 73 for
detailed information regarding system LED indications.
__ 5. Does IBM Network Station display on the monitor?
Yes No
One of the following may be true:
a. Verify that the monitor is on, and tighten the monitor cable
connections.
b. The Network Station has failed a self-test during the startup
sequence. LED indications or beep sequences occur when
this is true. Refer to "Indicators of Network Station
problems" on page 73 for detailed information about
Network Station problem indicators.
c. You have not configured the Network Station for the server
operating system. The Change Firmware Support menu
displays when this is true. See "Part 3. Configuring the
Network Station" on page 37.
d. The monitor attached to the Network Station may not be
working properly. Consider swapping the monitor with one
that you know works properly.
e. The Network Station logic unit may be defective. Consider
replacing the Network Station logic unit (see "Chapter 2.
Replacing Network Station parts" on page 9 for more
information).
__ 6. Do any error codes or text messages display on the monitor?
Note: Error messages do not display before IBM Network Station
displays on the monitor.
No Yes
Chapter 11. Identifying problems with hardware that is configured for NS Boot
71