Chapter 2. Replacing Network Station Parts; Servicing The Network Station; Replacing The Logic Unit - IBM 8364 E series User Manual

Chapter 2. Replacing Network Station parts

This chapter defines the service strategy for the Network Station. For
information on ordering Network Station parts, refer to "Chapter 3. Ordering
Network Station parts" on page 11. "Chapter 4. Performing hardware
procedures" on page 17 provides the instructions that are needed to install
and remove parts, and perform other hardware-related procedures on the
Network Station.

Servicing the Network Station

All Network Station parts except the power supply are Customer Replaceable
Units (CRUs). The power supply is a part of the logic unit drawer assembly,
and should be replaced by the customer as an entire drawer CRU, if defective.
Country warranty service terms and conditions apply.
Note: The power supply part that can be exchanged or replaced is available

Replacing the logic unit

To replace a Network Station logic unit, the customer must transfer features,
such as DIMMs and optional PCI adapter cards, to the replacement unit. IBM
delivers CRUs to the customer for exchange, and the customers return
defective part to IBM under the basic service offering. For upgrade service
offerings, a service representative delivers replacement parts, transfers features
and returns defective parts to IBM.
Customers must not remove the lithium battery when preparing a logic unit
for shipping. If customers do not transfer their features, the replacement units
will not operate properly. See "Handling static-sensitive devices" on page viii
for information about handling CRU parts.
Refer to "Chapter 4. Performing hardware procedures" on page 17 for
instructions on installing and removing Network Station parts. Refer to
"Ordering replacement parts" on page 11 to determine CRU part numbers for
replacement parts.
© Copyright IBM Corp. 1999
for onsite service from a service representative, or to be used as a
replacement part in a depot repair center.
9