IBM 8364 E series User Manual page 118

card" on page 24). Both procedures will reset the administrator password to
the default value, IBMNCD. To change this setting, refer to "Changing the
administrator password" on page 58.
Attention: All configuration error codes appear in the upper left corner of
the screen.
Table 10. Configuration errors
Error code
114, 1805,
1885
161
162
165
164
1101
201
301, 303
106
IBM Network Station
Error message
Adapter ROM An option ROM
Error has failed
Bad CMOS CMOS was
Battery corrupted
Configuration Configuration has
Error changed from
previous boot
Date and Time Battery has failed
Incorrect
Memory Size Memory size has
Error changed
System Board Unknown failure
Failure
Memory Error Memory test failed Ensure that any memory
Keyboard Error Keyboard test
failed
Cause Suggested actions
Restart the Network Station; or,
Replace the logic unit (see
"Replacing the logic unit" on
page 9).
Perform the procedure,
"Exchanging the lithium
battery" on page 20.
Action is not necessary.
Perform the procedure,
"Exchanging the lithium
battery" on page 20.
Action is not necessary.
Clear CMOS (see "Clearing the
administrator password and
CMOS, creating a recovery
CompactFlash card, and reading
a CompactFlash card" on
page 24); or, replace the logic
unit (see "Replacing the logic
unit" on page 9).
DIMMs are correctly installed;
or, replace the memory DIMM
(see "Exchanging the memory"
on page 20).
Restart the Network Station and
do not press any keys; or, verify
that you connected the
keyboard cable to the correct
port on the back of the
Network Station. If the problem
continues, replace the keyboard.