Actual Signals - ABB ACS 600 User Manual

2 Actual Signals

Code Parameter
2 ACTUAL
SIGNALS
2.05 DC REF Q-CTRL
2.06 DC REF RAMP
2.07 DC REF INITIALIZ
3 Actual Signals
Code Parameter
3 ACTUAL
SIGNALS
3.12 PP 0 TEMP
3.13 PP 1 TEMP
3.14 PP 2 TEMP
3.15 PP 3 TEMP
ACA 635 IGBT Supply Sections
Unit Description
V Intermediate circuit voltage reference calculated by reactive power
control
V Ramped and limited intermediate circuit voltage reference for
power control
V Initialized intermediate circuit voltage reference based on line-side
ID Run. The voltage reference is calculated from DC voltage
measurement and is approximately Ö2 × supply network voltage.
Unit Description
These parameters are visible in parallel connected units (frame
sizes 2xR11i/R12i and 4xR11i/R12i) only and show the highest
power plate temperatures of the phase module blocks no. 1 to 4
(see Chapter 3 – Hardware Description:
on the NINT board indicate the hottest phase (U, V or W) of each
module block. See Chapter 7 – Fault Tracing /
of an Earth Fault
°C
The highest power plate temperature of phase module block 1.
°C
The highest power plate temperature of phase module block 2.
°C
The highest power plate temperature of phase module block 3.
°C
The highest power plate temperature of phase module block 4.
IGBT Supply
Indication.
Chapter 8 – Parameters
Integer
Scaling
1 = 1 V
1 = 1 V
1 = 1 V
Integer
Scaling
Unit). LEDs
What to Do in Case
1 = 1 °C
1 = 1 °C
1 = 1 °C
1 = 1 °C
8-3