Isu-Related Information In Other Manuals - ABB ACS 600 User Manual

Chapter 1 – Introduction
ISU-related
Information in Other
Manuals
Task
Mechanical and
Electrical Installation of
ISU
Preventive
Maintenance
Installation of Optional
Modules and
DriveWindow
Associating ISU with
DriveWindow
User Interface
1-2
Items concerning the ACA 635 not described in this manual are listed
below with a reference to the manual where they are described. For EN
codes of the manuals refer to the inside of the front cover of this
manual.
Described in
ACS 600 MultiDrive
Hardware Manual (EN
code: 63700118) or
ACx 6x7 Hardware
Manual (EN code:
61329005)
as above
as above
DriveWindow Start-up
Guide EN code
36458585
The use of the Control
Panel is described in
detail in ACS 600
Firmware Manual (for
System, Standard or
Crane Drive Application
Program).
Instruction/Information
Perform the installation according to the instructions. See the required
general data from the ACS 600 MultiDrive Safety and Product
Information guide (or Appendix A in ACx 6x7 Hardware Manual, EN
code 61329005) and the ISU specific data from
Technical Data in this manual.
Install any optional modules and DriveWindow according to the
instructions given in Chapter 3 – Electrical Installation.
When associating DriveWindow 1.3 and 1.4 with the ISU proceed as
follows:
System Configuration Messages
Error: Encountered target 'ISU600-
xxxx-x' is unknown. Do you wish to
associate it?
Associate 'ISU600-xxxx-x' With
Do you wish association 'ISU600-
xxxx-x' = ACS600 MultiDrive be
permanent?
The user interface of the IGBT Supply Unit is a CDP 312 Control
Panel or PC, which is equipped with a DDCC board and DriveWindow.
ACA 635 IGBT Supply Sections User's Manual
Appendix A –
What to do
Click OK.
Choose ACS600 MultiDrive
from the list.
Click Yes.