Chapter 6 - Firmware Description; Overview - ABB ACS 600 User Manual

Overview

ACA 635 IGBT Supply Sections
Chapter 6 – Firmware Description
This chapter describes the IGBT supply unit control program. Note:
The parameters listed in this chapter need not be set in normal
use. They are mentioned for explaining the control principle only.
The following symbols are used:
Actual signal or parameter (described in
1.10
Parameters).
11.11 Parameter / actual signal below 100 (described in
– Parameters).
113.05 Parameter above 100. These parameters are not visible to
the user unless passcode is entered for the Parameter Lock
in Parameter 16.03 PASS CODE. These parameters are not
allowed to be changed without ABB's permission.
Chapter 8 –
Chapter 8
6-1