iM80 Patient Monitor Service Manual
Chapter 8 Disassembling the Monitor
1 Only qualified service personnel shall open the monitor housing.
2 Switch off the monitor and disconnect it from AC power before disassembling the
monitor.
3 After any repair of the device, perform safety tests prior to use.
8.1 Tools Required
1 – A cross-head screwdriver
2 – A flat-head screwdriver
3 – A M3 nut driver
4 – A pair of pliers
8.2 Replacing Fuses
To replace the melted fuses,
1. Switch off the monitor and disconnect it from power.
2. The back of the monitor should face the operator.
3. Pull out the fuse box and pick the inside fuse up with a flat-head screwdriver.
WARNING
- 38 -
Disassembling the Monitor