Installing The Stopper Assembly - Seagull Models DUAL ACE Instruction Manual

DUAL ACE.
Repeat the procedure for the other
aileron servo.
ATTACHMENT ENGINE MOUNTING
BOX.
See pictures below.
FUEL TANK.

INSTALLING THE STOPPER ASSEMBLY.

! 1) Using a modeling knife, carefully cut
off the rear portion of one of the two nylon tubes
leaving 1/2" protruding from the rear of the
stopper. This will be the fuel pick up tube.
10
White glue or
epoxy glue.
Instruction Manual.
! 2) Using a modeling knife, cut one length
of silicon fuel line (not included) to 2-1/4" long.
Connect one end of the line to the weighted
fuel pickup and the other end to the nylon pick
up tube.
! 3) Carefully bend the second nylon tube
up at a 45º angle. This tube is the vent tube.
! 4) Carefully heat the vent tube using a
heat gun or lighter to permanently set the
angle of the tube.
Vent tube.
Clunk.
When the stopper assembly is installed in
the tank, the top of the vent tube should rest
just below the top surface of the tank. It should
not touch the top of the tank.
Fuel line.