Seagull Models DUAL ACE Instruction Manual page 2

DUAL ACE.
INTRODUCTION.
Thank you for choosing the DUAL ACE ARTF by SEAGULL MODELS. The DUAL ACE was
designed with the intermediate/advanced sport flyer in mind. It is a airplane which is easy to fly and
quick to assemble. The airframe is conventionally built using balsa, plywood to make it stronger than
the average ARTF , yet the design allows the aeroplane to be kept light. You will find that most of the
work has been done for you already.Flying the DUAL ACE is simply a joy.
This instruction manual is designed to help you build a great flying aeroplane. Please read this
manual thoroughly before starting assembly of your DUAL ACE. Use the parts listing below to
identify all parts.
WARNING.
Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is
capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU
ASSUME ALL RISK & RESPONSIBILITY.
If you are inexperienced with basic R/C flight we strongly recommend you contact your R/C supplier
and join your local R/C Model Flying Club. R/C Model Flying Clubs offer a variety of training
procedures designed to help the new pilot on his way to successful R/C flight. They will also be able
to advise on any insurance and safety regulations that may apply.
ADDITIONAL ITEMS REQUIRED.
!
.46cu.in 2 - stroke engine (2pcs).
!
Computer radio with seven digital
servos.
!
Glow plug to suit engine.
!
Propeller to suit engine.
!
Protective foam rubber for radio
system.
!
Silicone fuel line.
TOOLS & SUPPLIES NEEDED.
!
Thick cyanoacrylate glue.
!
30 minute epoxy.
!
5 minute epoxy.
!
Hand or electric drill.
!
Assorted drill bits.
!
Modelling knife.
!
Straight edge ruler.
!
2mm ball driver.
!
Phillips head screwdriver.
!
220 grit sandpaper.
!
90° square or builder's triangle.
!
Wire cutters.
!
Masking tape & T-pins.
!
Thread-lock.
!
Paper towels.
2
Instruction
PARTS LISTING.
FUSELAGE ASSEMBLY
!
(1) Fuselage.
!
(1) Canopy hatch.
WING ASSEMBLY
!
(1) Right wing half with pre-installed
aileron.
!
(1) Left wing half with pre-installed
aileron.
!
(1) Aluminium dihedral brace.
Tail section assembly
!
(1) Horizontal stabilizer with pre-
installed elevator halves.
!
(1) Vertical stabilizer with pre-
installed rudder halves.
Some more parts.
HARDWARE PACK
COWLING
Landing gear.....
Manual.