Start And Stop Of A Tympanometric Test - Interacoustics AT235 Instructions For Use Manual

Impedance audiometer
Hide thumbs Also See for AT235:
Table of Contents

Advertisement

Available languages

Available languages

AT235 Instructions for Use - EN
I
J
K
L
M
N
3.5.7 Start
stop of a tympanometric test
and
After startup the AT235 is ready to automatically start a measurement as soon as it detects that the probe is
in the ear. When the probe is in the ear the test can be manually stopped (or paused) and again started by
pressing the "Start/stop" button (22) or by pressing the probe button. When the probe is out of the ear the
test can be stopped (as if it is paused before inserting the probe) or started by pressing the "Start/Stop"
button (22). Using the probe button while the probe is out of ear will result in changing the selected ear side
and at the same time restoring the automatic start function if necessary.
Press the "Store" button (8) for storing points in the audiogram.
Press the "No Resp" button (9) for storing a no response indication in the
audiogram.
Press the "Delete Curve" button (10) for deleting the curve of the current
measurement type.
Press the "Ext Range" button (11) to activate the maximum intensity range of the
transducer.
Press the "Freq -" button (12) to lower the test frequency.
Press the "Freq +" button (13) to increase the test frequency.
Page 25

Advertisement

Table of Contents
loading

Table of Contents