Table of Contents
Advertisement
2.2
Checking the setup
This section provides an overview of the setup procedure that is required for each net-
work printing method.
Peer-to-peer printing
1
Connect the network cable. (Refer to "Connecting to a local area network
(LAN)" on page 1-12.)
2
From the machine's control panel, specify the IP address, subnet mask and de-
fault gateway. (Refer to "Specifying an IP address" on page 2-9.)
3
Print the settings information, and then check the settings. (Refer to "Printing
the settings information" on page 2-13.)
–
If optional fax kit FAX-4000 and image controller PCL-4000 are not in-
stalled, the settings information cannot be printed from the machine's con-
trol panel.
4
Install the printer driver. The Peer-to-Peer Utility is installed when the printer
driver is installed.
–
If the GDI driver is to be installed, refer to the User's Guide for the GDI
printer controller, included with this machine.
–
If the PCL driver (optional) is to be installed, refer to the User's Guide for
image controller PCL-4000, included with the PCL-4000 option.
5
Add the network port to the computer. (Refer to "Connecting the computer and
this machine over a network" on page 2-15.)
Reminder
When installing the printer driver on an operating system other than Windows 98
SE or Windows Me, the Peer-to-Peer Utility is not installed.
2-5
Advertisement
Table of Contents
