Mastless - Toyota 7FBEF 15 Service Manual

MASTLESS

I General
Mastless vehicles are available optionally.
• These are without the mast ASSY, lift bracket, backrest and fork.
• The high-pressure hose from the mast to the control valve is not provided. The control valve fitting is
attached with a blind plug.
• The tilt cylinder is for the FSV mast. The pin for fixing the tilt cylinder on the mast is not provided.
• The name plate punched with the model, frame No., manufacturing year, front tread, tire size, tire
pressure, voltage, battery weight and rated load is riveted in the same position as on the standard
model.
• A spare nameplate punched with the model, frame No., manufacturing year, voltage, battery weight and
rated load is supplied with the vehicle.
Note:
• Always install the 7FBEF series mast for SAS manufactured by Toyota as described on the
repair manual.
• SAS matching is a must after mast installation.
• Refer to the table in the mast specification section for the allowable load to be punched on the
nameplate (except when the side shifter is installed).
9-3
2
3
9