Outside Diameter And Inside Diameter Of Bearing Fit - Mitsubishi S6R Series Service Manual

2.9 Outside Diameter and Inside Diameter of Bearing Fit

(Oil pressure governor spec)
Rotate the bearing and if the rotation is not smooth, replace the bearing with a new one.
Inspect the fit of drive shaft, idler shaft and bearing. If significant wear is found, replace them with new ones.
Inspect the fit of drive case and bearing. If significant wear is found, replace them with new ones.
Outside diameter and
inside diameter of bearing fit
* Woodward PSG type governor and EG-3P type governor
Item
Inside diameter of drive shaft case bearing housing
Drive shaft side bearing
Outside diameter of drive shaft bearing fit
Outside diameter of drive shaft gear fit
Inside diameter of drive gear fit
Inside diameter of idler shaft case bearing housing
Idler shaft side bearing
Outside diameter of idler shaft bearing fit
Outside diameter of idler shaft gear fit
Inside diameter of idler gear fit
Chapter 8 FUEL SYSTEM
Nominal value
ø52 mm [2.05 in.]
outside diameter ø52 mm [2.05 in.]
Inside diameter ø25 mm [0.98 in.]
ø25 mm [0.98 in.]
ø26 mm [1.02 in.]
ø26 mm [1.02 in.]
ø47 mm [1.85 in.]
outside diameter ø47 mm [1.85 in.]
Inside diameter ø20 mm [0.79 in.]
ø20 mm [0.79 in.]
ø24 mm [0.94 in.]
ø24 mm [0.94 in.]
Standard value
51.988 to 52.018 mm
[2.0468 to 2.0480 in.]
51.987 to 52.000 mm
[2.0467 to 2.0472 in.]
24.990 to 25.000 mm
[0.9839 to 0.9843 in.]
25.002 to 25.011 mm
[0.9843 to 0.9847 in.]
26.035 to 26.048 mm
[1.0250 to 1.0255 in.]
26.000 to 26.013 mm
[1.0236 to 1.0241 in.]
46.989 to 47.014 mm
[1.8500 to 1.8509 in.]
46.989 to 47.000 mm
[1.8500 to 1.8504 in.]
19.990 to 20.000 mm
[0.7870 to 0.7874 in.]
20.002 to 20.011 mm
[0.7875 to 0.7878 in.]
24.035 mm 24.048 mm
[0.9463 to 0.9468 in.]
24.000 to 24.013 mm
[0.9449 to 0.9454 in.]
8-37