Valve Bridge - Remove; Rocker Case - Remove; Cylinder Head Assembly - Remove; Valve Sinkage - Measure - Mitsubishi S6R Series Service Manual

Chapter 5 DISASSEMBLY OF BASIC ENGINE

1.7 Valve Bridge - Remove

Remove the valve bridge and bridge cap.
Note: Be careful not to drop the bridge cap into the cylinder
head.

1.8 Rocker Case - Remove

(1) Remove the snap ring of water outlet connector.
(2) Slide the water outlet connector to the snap ring groove
side, and separate it from the next rocker case.
(3) Remove the rocker case from the cylinder head.

1.9 Cylinder Head Assembly - Remove

When removing the cylinder head gasket, be careful
not to damage the cylinder head or crankcase surface
with a screwdriver or the like.
(1) Remove the cylinder head bolt.
(2) Remove the cylinder head by lifting it up using the
sling.
Note: Dowel pins are used to retain the cylinder head in a po-
sition. Therefore, pull the cylinder head vertical to the
mounting surface to remove.
(3) Remove the cylinder head gasket.

1.10 Valve Sinkage - Measure

Measure the valve sinkage, and know the current condition.
For the measurement procedure, refer to "Valve Sinkage -
Measure" of "ASSEMBLY OF BASIC ENGINE."
5-6
Valve bridge
Valve Bridge - Remove
Water outlet
connector
Rocker case
Rocker Case - Remove
Eye nut
P/N: 37591-02400
Cylinder Head Assembly - Remove
Bridge cap
Screw
Snap ring groove