Front Mechanism - Assemble; Front Cover - Install; Tension Pulley - Install; Front Oil Seal - Install - Mitsubishi S6R Series Service Manual

Chapter 7 ASSEMBLY OF BASIC ENGINE

3. Front Mechanism - Assemble

3.1 Front Cover - Install

(1) Apply sealant (ThreeBond 1211) to the packing mount-
ing surface of the crankcase, and install the packing.
(2) Apply sealant (ThreeBond 1211) to the packing for
front cover mounting surface, and install the front
cover.
(3) Tighten the bolt.
(4) Check that the lower face of front cover is flush with
the bottom of crankcase.
Cut off any excessive packing neatly.

3.2 Tension Pulley - Install

(1) Install the tension pulley to tension plate, then tighten
the bolts.
(2) Install the tension plate to front cover and bracket.

3.3 Front Oil Seal - Install

With the front seal installer assembly, install the front oil
seal.
(1) Apply clean engine oil evenly to the oil seal lip.
Note: Pay attention to the installing side of oil seal, and be
careful not to damage the oil seal.
(2) Install the guide flange to the crankshaft front end, and
secure it with the insert bolts.
(3) Set the oil seal to insert and install it to the guide flange.
(4) Tighten the bolt on guide flange to insert the oil seal
into the front cover.
(5) Remove the installer assembly.
7-18
Cutter
Front Cover - Install
Tension plate
Front cover
Tension Pulley - Install
Insert bolt
Guide flange
Insert
Socket bolt
Bolt
Swing
washer
Front Oil Seal - Install (1)
15.5 mm
[0.610 in.]
Front seal installer
assembly
P/N:37591-05010
Front Oil Seal - Install (2)
Packing
Tension pulley
Front seal installer
assembly
P/N:37591-05010
17.5 mm
[0.689 in.]
Slinger
Oil seal