Valve Clearance - Check And Adjust; Fuel Injection Timing - Check And Adjust - Mitsubishi S6R Series Service Manual

5.13 Valve Clearance - Check and Adjust

Adjust the valve clearance when the engine is cold.
Note:(a) The inlet valves are on the left side and exhaust
valves are on the right when the cylinder head is
viewed from camshaft side.
(b) The valve clearance standard values are shown on
the caution plate on the No. 1 cylinder rocker cover.
Item
Inlet
Valve clearance
Exhaust
(1) Adjust the valve clearance in the firing order at TDC of
compression stroke by turning crankshaft in the normal
direction.
(2) On each cylinder, the piston is at the top dead center on
compression stroke, when corresponding cylinder num-
ber stamped on damper is aligned with pointer, and
inlet valves and exhaust valves are not pushed with
push rod.
(3) Insert a thickness gauge between rocker arm and bridge
cap to measure the clearance. Tighten or loosen the
screw to adjust the clearance where the movement of
thickness gauge becomes slightly restricted.
(4) After the adjustment tighten the lock nut firmly to the
specified torque. Then, check the clearance again.

5.14 Fuel Injection Timing - Check and Adjust

5.14.1 Specified Value of Fuel Injection Timing - Check
The fuel injection timing varies depending on the engine
output, speed and specifications. Be sure to check the plate
on the No. 1 rocker cover for the fuel injection timing.
Standard value
0.6 mm [0.024 in.]
0.8 mm [0.031 in.]
No. 1 Cylinder Compression Top Dead Center - Check
64 ± 3.2 N·m
{6.5 ± 0.33 kgf·m}
[47 ± 2.4 lbf·ft]
Chapter 7 ASSEMBLY OF BASIC ENGINE
Valve Clearance Label - Location
Firing order
Cylinder number: 1-5-3-6-2-4
Valve Clearance - Adjust
Specified Value of Fuel Injection Timing - Check
VA LV E C L E A R A N C E ( C O L D )
0.6 0.8
I N L E T
mm [in.] EXHAUST mm [in.]
F I R I N G O R D E R
1 - 5 - 3 - 6 - 2 - 4
BTDC
F U E L I N J E C T I O N T I M I N G
C O N - R O D R A N K
Check for compression
top dead center
VA LV E C L E A R A N C E ( C O L D )
0.6 0.8
I N L E T mm [in.] EXHAUST mm [in.]
F I R I N G O R D E R
1 - 5 - 3 - 6 - 2 - 4
BTDC
F U E L I N J E C T I O N T I M I N G
C O N - R O D R A N K
7-31