Using The Speed - Raymarine i50 Depth Installation And Operation Instructions Manual

i. Use the Timer or Reset buttons to change
the reset option to Yes.
ii. Press the Speed button to reset your display
to factory default settings.
3. After a reset it is recommended that you check
the data master status of the display to ensure
it is set correctly. Refer to
details.
Note: To exit the Dealer Calibration pages at any
time, press and hold the Speed and Trip buttons
at the same time for approximately 2 seconds.
52
7.4 Data master for
7.9 Using the speed pages
To cycle through the speed pages follow the steps
below:
1
5
S pe e d
S pe e d
4
1. Current Speed page
2. [1] Maximum Speed page
3. [1] Average Speed page
4. [2] VMG (wind) page
5. [3] SOG page
Note:
• [1] These pages are temporary pages and will
revert back to the previous permanent page
after 8 seconds of inactivity.
• [2] The VMG (wind) information is only available
if your unit is part of a SeaTalk or SeaTalk
network which has a compatible wind instrument
and transducer connected.
• [3] SOG information is only available if your unit
is part of a SeaTalk or SeaTalk
has a suitable GPS connected.
1. Use the Speed button to cycle through the
available speed pages.
2. From the Maximum Speed page or Average
Speed page, press and hold the Reset button for
approximately 3 seconds to reset the reading.
S pe e d
2
60 5
55
10
50 8
45 15
40 20
35 25
30
60 5
55
50 3 10
15
45
Re s e t
40 20
35 25
30
S pe e d
3
60 5
55
50 8 10
15
45
40 20
35 25
30
60 5
55
10
50 3
45 15
Re s e t
40 20
35 25
30
S pe e d
D12533-2
ng
ng network which
i50