Power; Data Master - Raymarine i50 Depth Installation And Operation Instructions Manual

8.3 Power

Powering on the unit
With power to the unit turned on but the unit switched
off:
1. Press and hold the Power button until the unit
powers on and data is displayed (approximately
2 seconds).
Note: When power to the unit is turned on the unit
will switch on automatically.
Powering off the unit
1. Press and hold the Power button until the power
count down timer is displayed and reaches zero
(approximately 6 to 8 seconds).
i50 Tridata

8.4 Data master

Where a system contains more than one unit
capable of displaying a data type, the unit physically
connected to the transducer must be set as the data
master and any other units set as a repeater.
Checking i50 Tridata software version and
status
+
Depth S pe e d
During normal operation:
1. Press and hold the Depth and Speed buttons at
the same time for approximately 4 seconds, until
the Software Version page is displayed.
2. Press the Depth button to display the instrument
status.
Master (transducer connected) or Repeater (No
transducer connected).
3. To change the depth status:
i. Press the Trip and Reset buttons at the same
time.
The status will flash.
ii. Use the Trip or Reset button to switch the
status between Master or Repeater.
i. Press the Trip and Reset buttons at the same
time to confirm the new instrument status.
4. Press the Depth button again to begin speed run
calibration.
5. To exit the Intermediate calibration settings at
any time, press and hold the Depth and Speed
buttons at the same time for approximately 4
seconds:
60 5
55
4 10
50
45 15
40 20
35 25
30
Depth
D12461-2
57