Cruise Speed; Latitude; System Reset - Raymarine SmartPilot X-5R Drive Installation & Setup

Chapter 4: SmartPilot X-5R Drive Settings
Options
OFF
1
2

Cruise speed

Sets the cruise speed value to the boat's typical cruising speed. If neither the speed
through the water nor the speed over ground are available via SeaTalk or NMEA, the
SPX-5R Drive system will use the cruise speed value you set here as a default when
when adjusting autopilot settings.
Screen Text
CRUISE SP

Latitude

If valid latitude data is available via SeaTalk or NMEA, the SPX-5R Drive system will
use this data instead of the calibration value.
Screen Text
LATITUDE

System reset

CAUTION: Losing settings at system reset
Do NOT select System RESET unless advised to do so by a
Raymarine dealer. If you complete a reset you will lose the SPX-5R
Drive system calibration settings. You will then need to repeat the
SPX-5R Drive system commissioning process.
Carrying out a System reset will reset User calibration, Seatrial calibration and Dealer
calibration settings to their default values.
Note:
the Display calibration settings will not change, as these are stored in each individual con-
troller.
To carry out a system reset:
1. Select the System reset (RESET) screen in Dealer calibration.
+1
2. Press
Joystick off
Proportional power steer
Proportional power steer applies rudder in proportion to joystick movement –
the further the joystick is held over, the greater the applied rudder.
Bang-bang power steer
Bang-bang power steer applies continuous rudder in the direction of the lever
movement – to improve control, the speed of rudder movement changes with
the angle of the lever. For maximum speed, push the lever hardover. If you
return the lever to the center position, the rudder will remain in its current posi-
tion.
Range
4
to
Range
0°
to
auto
, then press .
60
knots
80°
in 1° steps
59