Transducer Connections - Raymarine i50 Depth Installation And Operation Instructions Manual

4.4 Transducer connections

i50 Depth connection
1
3
Item Cable color
1 Black
2 Blue
3
Screen
i50 Speed connection
Item Cable color
1 Brown
2 White
3 Screen
4 Green
5 Red
i50 Tridata connection
1
3
26
Item
1
2
3
4
5
6
7
8
Making transducer connections
D12376-1
Signal name
Although the transducer cable is fitted with spade
connectors for direct connection to the rear of the
Piezoceramic –
unit, it may be necessary to remove these to facilitate
Piezoceramic +
installation, e.g. if the cable has to be routed through
narrow apertures. 1/8th spade terminals will be
0 V (shield)
required (not supplied), to replace those removed.
When fitting the new spade connectors, prepare the
cables as detailed below:
1
2
1. Prepare the cable as shown in 1 above.
3
2. Fold back the wire strands and insert into the new
spade connector as shown in 2 above.
2
3. Ensure the wire strands do not extend beyond
1
the rear of the spade connector insulation.
D12390-1
4. Crimp the connector to the wire.
Signal name
Temperature 0 V
Temperature
(signal)
Speed 0 V (shield)
Speed (signal)
Speed V+
D12393-1
Cable color Signal name
Black (Depth) Piezoceramic –
Blue (Depth) Piezoceramic +
Screen (Depth) 0 V (shield)
Brown (Speed) Temperature 0 V
Temperature
White (Speed)
(signal)
Screen (Speed) Speed 0 V (shield)
Green (Speed) Speed (signal)
Red (Speed) Speed V+
50 mm
6 mm
D12359-1
i50