Dodge RAM 1500 1998 Owner's Manual page 1773

21 - 70 MANUAL TRANSMISSION - NV4500
MANUAL TRANSMISSION - NV4500 (Continued)
(14) Install thrust washer pin in shaft (Fig. 91).
Fig. 91 THRUST WASHER PIN
1 - THRUST WASHER PIN
2 - SECOND GEAR
(15) Install second gear thrust washer. Verify
washer is seated on gear and pin (Fig. 92).
Fig. 92 SECOND GEAR THRUST WASHER
1 - SECOND GEAR
2 - SECOND GEAR THRUST WASHER
3 - LOCATING PIN IN WASHER NOTCH
(16) Install second gear thrust washer snap ring
(Fig. 93). Verify snap ring is seated in mainshaft
groove.
(17) Install third gear bearing spacer on shaft and
seat it against thrust washer snap ring (Fig. 93).
(18) Install third gear bearing on mainshaft (Fig.
94). Bearing should be flush with mainshaft hub.
NOTE: If bearing is not flush with hub, the bearing
spacer or snap ring was not installed.
(19) Install third gear over bearing and onto main-
shaft (Fig. 95).
Fig. 93 SNAP RING AND THIRD
1 - SECOND GEAR THRUST WASHER
2 - THRUST WASHER SNAP RING
3 - THIRD GEAR BEARING SPACER
Fig. 94 THIRD GEAR BEARING
1 - THIRD GEAR BEARING
Fig. 95 THIRD GEAR
1 - THIRD GEAR
DR