Table of Contents
Advertisement
2
Replacing Assembly Units
2.1
Tools
Do not use any worn of damaged tools.
Only use tools and testing devices that are suitable for the task at hand.
cab special tools:
•
Test collar for transfer ribbon winder (cab item number: 5534199)
Standard tools:
•
Phillips-head screwdriver, size 1
•
Allen key 1,5 mm
•
Screw driver Torx, size TX 20
•
Snap ring pliers ZGG 0
•
Cylindrical dynamometer (spring scale), 0 - 10 N
•
Cylindrical dynamometer (spring scale), 0 - 25 N
•
Jaw wrench 8 mm
2.2
Replacing the Printhead
The printhead of the label printer can be replaced without the need for fine adjustment. The printhead must be
replaced if worn or when switching to a printhead with higher or lower resolution.
3
4
Fig. 1
Structure of the printhead
!
Attention!
The printhead can be damaged by static electricity discharges and impacts!
Set up printer on a grounded, conductive surface.
Ground your body, e.g. by wearing a grounded wristband.
Do not touch contacts on the plug connections (1, 2).
Do not touch heating line (5) with hard objects or your hands.
1
2
4
5
1 Data connector
3
2 Power connector
3 Threaded holes
4 Catching holes
5 Heating line
7
Hide quick links:
Advertisement
Table of Contents
