The Basics Of Operation; Getting Started; Starting A Workout - SteelFlex XT-2700 User Manual

T B
HE ASICS OF
G S
ETTING
After the treadmill is correctly installed and plugged in, it's time to start
our workout.
Begin by depressing the power switch, located in the front of the treadmill
near the powercord, to the ON position.
S W
ET EIGHT
After the power switch is depressed to the ON position, the Set Weight LED
will light and the display console will read the last weight entered from
the previous workout. If no weight was previously entered or the system
was reset (refer to the Stop button information), the Main window will
display 150 (factory default).
NOTE:
S
TARTING A
When you are ready to begin a workout, check that there are no
obstructions near the treadmill. Also confirm there is nothing located under
the treadmill especially if there are children or pets present. Carefully reach
down and press the power switch to the ON position. You will hear an
audible beep and the Display console will prompt you to enter your weight.
Use the Speed or Incline Arrow keys to raise or lower the weight value
displayed in the LED Matrix window. Once the desired weight is displayed,
press the Enter button to continue.
21
XT-3200/3300/3600/4600
4800/5600/5700 Treadmill
O
PERATION
TARTED
F
OR XT-4600/4800/5600/5700
If the Enter button is not pressed within 6
seconds, the system will accept the displayed
weight and begin a Manual workout program.
W
ORKOUT
M O .
ODELS NLY