Sms Processing - 2N BRI Lite User Manual

AT!Rx
AT!RR
AT!RX

SMS Processing

SMS Sending/Receiving Commands
AT!G=A6
AT!G=55
Control SMS
AT^SX=ch
AT^SR=ch,ix
AT^SD=ch,ix
AT^SM=ch,len,pdu,cs
um
AT^SG=grp,len,pdu,cs
um
SMS from BRI GSM Gateway
*smsinc: ch,ix,sts
*smsrep: ch,ix
List of Terminal AT Commands
x=3 – Layers TCP, Telnet
x=4 – Layer Telnet
Start tracing of ISDN BRI & GSM on layer x
x=1 – Layers 1,2,3,4
x=2 – Layers 2,3,4
x=3 – Layers 3,4
x=4 – Layer 4
Start tracing (AT!R2) to COM1 interface
Stop tracing (AT!R2) to COM1 interface
Start low-level controlling for SMS (can run only on one port)
Stop low-level controlling on used port
...(sms listing) request to list all SMS messages and status
confirmations saved on SIM card. Possible answers:: *smserr
(busy,list) or *smsinc (ix=1..255) for each saved SMS or status
SMS messages, end of list or empty SIM card - *smsinc (ix=0).
...(sms read) request to read SMS or status SMS saved in SIM card.
Possible answers: *smserr (busy,read) or *smspdu
...(sms delete) request to delete SMS message (or status SMS
message). Possible answers: *smserr (busy,delete) or *smsdel
...(sms to module) request to send message via GSM module 0..31
or via any GSM module (ch=32). Possible answers: *smserr
(busy,write) or *smsout
...(sms to group) request to send SMS message via GSM group 1..8.
Possible answers: *smserr (busy,write) or *smsout
... SMS message was received and saved into SIM card:
Ch ...GSM module number 0..31
Ix ...index number of saved SMS 0..255
Sts ...SMS status
...SMS status confirmation was received and saved to SIM card (this
message is only for GSM modules TC35 and GM47)
6.3
89