Perc H730P Slim Card; Removing A Perc H730P Slim Card - Dell PowerEdge FC630 Owner's Manual

7. connector
1. Install the hard drives or SSDs in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Removing a hard drive or SSD
Removing the hard drive or SSD backplane
After working inside your system
Installing the hard drive or SSD cage
Installing a hard drive or SSD

PERC H730P slim card

The PERC H730P slim card is supported only on systems with eight 1.8-inch SSDs and two processors.

Removing a PERC H730P slim card

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
4. Remove the cooling shroud.
1. Loosen the two retention screws on the PERC H730P slim-card cable connector.
2. Holding the pull tag, lift the PERC H730P slim-card cable connector from the system board
connector.
3. Press the release latch on the side of the chassis to the unlock position and slide the PERC H730P
slim card toward the back of the system.
CAUTION: To prevent damage to the PERC H730P slim card, you must hold the card only by
its edges.
4. Lift the card up and away from the system.
113