Dell PowerEdge FC630 Owner's Manual page 79

4. If installed, remove the internal USB key.
5. If installed, remove the SD card(s).
1. Remove the two screws securing the IDSDM card to the system board.
2. Remove the SD card slot bracket.
CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.
3. Lift the card up and away from the system.
Figure 23. Removing the optional IDSDM card
1. IDSDM card
3. SD card slot bracket
5. IDSDM card connector on the system
board
1. Install the IDSDM card.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Installing the optional IDSDM card
Before working inside your system
Replacing the internal USB key
Replacing an SD card
After working inside your system
2. screw (2)
4. PCIe mezzanine card support bracket
6. standoff (2)
79