Rspi Card (Optional); Removing The Optional Rspi Card - Dell PowerEdge FC630 Owner's Manual

5. IDSDM card connector on the system
board
1. If applicable, install the SD card(s) and the internal USB key.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Removing the optional IDSDM card
Before working inside your system
Replacing the internal USB key
Replacing an SD card
After working inside your system

rSPI card (optional)

rSPI (restore Serial Peripheral Interface) is a SPI flash device to store information about the system Service
Tag, system configuration, or iDRAC license.

Removing the optional rSPI card

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
1. Remove the two screws securing the rSPI card to the system board.
CAUTION: To prevent damage to the rSPI card, you must hold the card only by its edges.
2. Lift the card up and away from the system.
6. standoff (2)
81