Mini Perc Card; Removing The Mini Perc Card - Dell EMC PowerEdge XE7440 Installation And Service Manual

Figure 26. Installing the M.2 riser board
Next steps
1. Install the air shroud.
2. Install the sled.
3. Follow the procedure listed in

Mini PERC card

Removing the mini PERC card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the sled.
4. Remove the air shroud.
5. Remove the PCIe dummy
Steps
1. Loosen the captive screw and remove the three screws securing the mini PERC card module to sled.
2. Lift the mini PERC card module from the sled.
After working inside your
Safety instructions.
Before working inside your
bracket.
system.
system.
Installing and removing system components 61