Dell PowerEdge FC630 Owner's Manual page 72

WARNING: The memory modules are hot to touch for some time after the system has been
powered down. Allow time for the memory modules to cool before handling them. Handle the
memory modules by the card edges and avoid touching the components or metallic contacts on
the memory module.
1. Locate the appropriate memory module socket.
2. Press the ejectors on the memory module socket outward to allow the memory module to be
inserted into the socket.
CAUTION: Handle each memory module only on either card edge, making sure not to touch
the middle of the memory module.
3. Align the edge connector on the memory module with the alignment key on the memory module
socket, and insert the memory module in the socket.
NOTE: The memory module socket has an alignment key that allows you to install the memory
module in the socket in only one orientation.
CAUTION: To prevent damage to the memory module socket during installation, apply
pressure at both ends of the memory module evenly. Do not apply pressure to the center of
the memory module.
4. Press down on the memory module with your thumbs to lock the memory module into the socket.
NOTE: When the memory module is properly seated in the socket, the ejectors on the memory
module socket align with the ejectors on the other sockets that have memory modules
installed.
5. Repeat step 4 through step 7 of this procedure to install the remaining memory modules.
Figure 17. Installing the memory module
1. memory module
3. memory module ejector (2)
1. Follow the procedure listed in the After working inside your system section.
2. (Optional) Press F2 to enter the System Setup, and check the System Memory setting.
72
2. memory module socket