Initial System Setup And Configuration; Setting Up Your System; Idrac Configuration; Options To Set Up Idrac Ip Address - Dell PowerEdge FC630 Owner's Manual

Initial system setup and configuration

Setting up your system

Complete the following steps to set up your system:
1. Unpack the sled.
2. Remove the I/O connector cover from the sled connectors.
CAUTION: While installing the sled, ensure that it is properly aligned with the slot on the
enclosure to prevent damage to the sled connectors.
3. Install the sled in the enclosure.
4. Turn on the enclosure.
NOTE: Wait for the chassis to initialize before you press the power button.
5. Turn on the sled by pressing the power button on the sled.
Alternatively, you can also turn on the sled by using:
• The sled iDRAC. For more information, see the Log in to iDRAC section.
• The enclosure Chassis Management Controller (CMC), after the sled iDRAC is configured on the
CMC. For more information, see the CMC User's Guide at Dell.com/idracmanuals.
Related Links
Log in to iDRAC
Inside the sled

iDRAC configuration

The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more
productive and improve the overall availability of Dell systems. iDRAC alerts administrators to system
issues, helps them perform remote system management, and reduces the need for physical access to the
system.

Options to set up iDRAC IP address

You must configure the initial network settings based on your network infrastructure to enable the
communication to and from iDRAC. You can set up the IP address by using one of the following
interfaces:
Interfaces Document/Section
iDRAC Settings See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/
utility idracmanuals
4
25