Exerpeutic 1110.6 Owner's Manual page 12

Step 3
The Seat Cushion (6) has 2 sets of adjustment holes. It is recommended that
users between 5'1" – 5'6" use the holes at the rear of the seat. It is recommended
that users between 5'7" to 6'3" us the holes at the front of the seat.
To attach the Seat Cushion (6) to the Seat Post (5) first, align the holes, then attach it
using three Flat Washers (33) and three Hexagon Socket Bolts (58).Tighten the bolts with
the 5mm Allen Wrench with Phillips Screwdriver provided.
Connect the Connection Wires B (92) from the Seat Post (5) to the Connection
Wires C (93) from the Front Frame (2) as shown in Fig. AA-2.
Insert the Seat Post (5) into the Seat Post Plastic Bushing (12) and install the Seat
Adjustment Knob (14) to the threaded hole on the right side of the Front Frame (2) by
turning it clockwise, making sure that the safety pin of the Adjustment Knob (14) catches
one of the height adjustment holes of the Seat Post (5) Prior to fully tightening.
Hardware:
(14) Seat Height
Adjustment Knob
1 PC
ASSEMBLY
(33) Flat Washer Ø8.2
3 PCS
10
Tool:
13- 15mm Wrench
5mm Allen Wrench
with Phillips Screwdriver
(58) Hexagon Socket
Bolt M8x15 3 PCS